top of page
Tool Set

Installation

Horizontal Rod Rack

​

You will need the following tools:

  • 1200mm level

  • Cordless drill

  • 5mm drill bit

  • 13mm ring spanner

  • Stud finder

  • Measuring tape

  • Masking tape and Pencil

  • Masonary Drill and 10mm Bit if mounting to Brickwork

STEP 1

  • Locate timber wall framing using a stud finder

  • You'll need two studs approximately 1200mm to 1350mm apart

  • Mark height 100mm down from where you want the top of the Rodrack to finish

  • Ensure clearance of approximatley 900mm from a corner of the room

​​

IMG-3704.jpg

STEP 2

  • Drill 5mm pilot hole in centre of timber stud approx 60mm deep and install hanging bolt

  • Ensure 35mm of hanging bolt protudes from the wall

​

  • If mounting to brick wall, Drill a 10mm hole and insert the orange rawl plugs supplied

IMG-3711.jpg

​STEP 3

  • Slide Rod Rack over hanging bolt and install fixing washer and nut

IMG-3714.jpg

​STEP 4 

  • Plumb Rod Rack with a level and fix bottom through the lowest rod hole.  Do not overtighten

IMG-3721.jpg

​STEP 5 

  • Repeat process for the second rack 

  • Tighten fixing nut and with a 13mm socket or ring spanner

IMG-3726.jpg

​STEP 6

  • Place Rods in Rod Rack 

IMG-3736.jpg
bottom of page